manuals: replace hyphens with em dashes

Fix some hyphens being improperly used as em dashes.
See https://www.grammarly.com/blog/hyphens-and-dashes/

Using em dashes may also allow Sphinx to hyphenate
and break lines in the best way.

Note that the first character after an em dash not
supposed to be capitalized, unless a specific
rule applies, typically when what follows is a proper noun.

Fix a few misuses of parentheses in following text.

(From yocto-docs rev: 5918f019f63f6e820b1168f4cc001faa1d1cdc6f)

Signed-off-by: Michael Opdenacker <michael.opdenacker@bootlin.com>
Signed-off-by: Richard Purdie <richard.purdie@linuxfoundation.org>

1 files changed, 3 insertions, 3 deletions

diff --git a/documentation/sdk-manual/extensible.rst b/documentation/sdk-manual/extensible.rst
index 6bb262273d..ed9e43a2d8 100644
--- a/documentation/sdk-manual/extensible.rst
+++ b/documentation/sdk-manual/extensible.rst
@@ -252,7 +252,7 @@ command:
    -  *Left*: The left scenario in the figure represents a common
       situation where the source code does not exist locally and needs
       to be extracted. In this situation, the source code is extracted
-      to the default workspace - you do not want the files in some
+      to the default workspace --- you do not want the files in some
       specific location outside of the workspace. Thus, everything you
       need will be located in the workspace::
 
@@ -267,7 +267,7 @@ command:
    -  *Middle*: The middle scenario in the figure also represents a
       situation where the source code does not exist locally. In this
       case, the code is again upstream and needs to be extracted to some
-      local area - this time outside of the default workspace.
+      local area --- this time outside of the default workspace.
 
       .. note::
 
@@ -302,7 +302,7 @@ command:
       recipe for the code and places the recipe into the workspace.
 
       Because the extracted source code already exists, ``devtool`` does
-      not try to relocate the source code into the workspace - only the
+      not try to relocate the source code into the workspace --- only the
       new recipe is placed in the workspace.
 
       Aside from a recipe folder, the command also creates an associated