linux/meta-xilinx.git/conf/machine/boards/microzed, branch fidoMirror of git.yoctoproject.org/meta-xilinx.githttps://git.enea.com/cgit/linux/meta-xilinx.git/atom?h=fido2015-04-21T04:12:42+00:00zynq7-base.dtsi: Update bindings for PHYs attached to ethernet nodes2015-04-21T04:12:42+00:00Nathan Rossinathan.rossi@xilinx.com2015-04-21T04:12:42+00:00urn:sha1:965b8e54c45b60e9d346178c8285552c3d70c28d
* Update the bindings to match upstream definitions for the PHY
* The macb driver does not follow the phy-handle property and relies on
the PHY being located as the first child node of the ethernet device
* Remove the MDIO node and update all boards to nest the PHY as the
first child node of the ethernet device, this change is backward
compatible with the bindings for the linux-xlnx xemacps driver which
follows the phy-handle definition
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
boards/*-board.dtsi: Added USB PHY nodes for USB reset2015-04-17T05:50:26+00:00Nathan Rossinathan.rossi@xilinx.com2015-04-17T05:50:26+00:00urn:sha1:cfacbc9f19b9778eceda3f7ef51419ab70ebc4ac
* Added information about the GPIO/MIO reset pin so that the USB can be
reset by the kernel
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
microzed-zynq7: Add machine and device trees for microZed2015-04-14T04:00:45+00:00Nathan Rossinathan.rossi@xilinx.com2015-04-13T06:26:59+00:00urn:sha1:b43630ac75fe2cb9453c534ac5b4868b4ec96ca0
* Add machine config for the microZed board
* Add device tree includes for the microZed board
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>