init-install: Clean up partition alignment

The current partitioning scheme leaves a 1MB gap between all the
generated partitions by adding a 1 to the end of the last partition to
use as the start of the next. parted is smart enough to not overlap
start and end positions of the same value. This avoids the 1 MB gaps.

Rather than pad the disk with 1MB in the beginning and cut it off at the
MB boundary on the end, we can use 0% and 100% to allow parted to do the
required math and use as much of the disk as possible.

(From OE-Core rev: 8aac6ecc5194c734dfd3d677017ab3ea045b2339)

Signed-off-by: Darren Hart <dvhart@linux.intel.com>
Signed-off-by: Richard Purdie <richard.purdie@linuxfoundation.org>

1 files changed, 4 insertions, 4 deletions

diff --git a/meta/recipes-core/initrdscripts/files/init-install.sh b/meta/recipes-core/initrdscripts/files/init-install.sh
index 8d21dd1f58..0ac4949355 100644
--- a/meta/recipes-core/initrdscripts/files/init-install.sh
+++ b/meta/recipes-core/initrdscripts/files/init-install.sh
@@ -84,9 +84,9 @@ disk_size=$(parted /dev/${device} unit mb print | grep Disk | cut -d" " -f 3 | s
 swap_size=$((disk_size*swap_ratio/100))
 rootfs_size=$((disk_size-boot_size-swap_size))
 
-rootfs_start=$((boot_size + 1))
+rootfs_start=$((boot_size))
 rootfs_end=$((rootfs_start+rootfs_size))
-swap_start=$((rootfs_end+1))
+swap_start=$((rootfs_end))
 
 # MMC devices are special in a couple of ways
 # 1) they use a partition prefix character 'p'
@@ -113,13 +113,13 @@ echo "Creating new partition table on /dev/${device} ..."
 parted /dev/${device} mklabel msdos
 
 echo "Creating boot partition on $bootfs"
-parted /dev/${device} mkpart primary 1 $boot_size
+parted /dev/${device} mkpart primary 0% $boot_size
 
 echo "Creating rootfs partition on $rootfs"
 parted /dev/${device} mkpart primary $rootfs_start $rootfs_end
 
 echo "Creating swap partition on $swap"
-parted /dev/${device} mkpart primary $swap_start $disk_size
+parted /dev/${device} mkpart primary $swap_start 100%
 
 parted /dev/${device} print